License plate after autorization
userIdentifier
Set the value of the userIdentifier to CodeDuringAccept.
<PAYMENTSERVICE userIdentifier="CodeDuringAccept" >
CodeDuringAccept is the same as Code but the code is entered during accept, e.g., after authorize in post payment. The code is entered in the ConfirmTicketPopup
Post Payment settings
checkInTicket
| Value: | ConfirmAfterAuthorization |
| Description: | configures the printing of the check-in ticket. If not configured the system uses the value from the ticket attribute. ConfirmAfterAuthorization: A yes/no question is not stated until after the authorization has been done. |
If no printer is installed see the Digital receipts guide for additional configuration
postPayStartWithCard
| Value: | false |
| EV Use: | Must be set to false for EV charging! |
1.Start with selecting the charging point
2.Step up the time
3.Tap/insert the payment card when prompted
| Description: | Enable post payment flow to start with card or not. Normal flow is start with card. If set to false, the flow must begin with selecting check-in or check-out (this is normally done by the system when starting with card). By not starting with card the flow enables check-in with only a one tap for contact-less cards instead of double tap (not supported by all pay units). |
Pre-pay settings
ticketMode
| Value: | TicketBeforeAccept |
| Description: | This command allows you to choose the order in which ticket printout and accept of payment occur. TicketBeforeAccept Ticket is printed before accept. |
