The Terminal location tab shows the location of the terminal. If the coordinates are specified in the Terminal location tab, the geographic location of the terminal can be displayed on a map.
To add the terminals location on the map you must zoom in and then fine-tune the location by dragging the red pin symbol 
into the right location. Information about latitude and longitude is then calculated automatically and displayed in the fields below the map. Latitude and longitude information may also be entered manually in the related fields. When you are satisfied with the location, click 
to save the terminals location on the map.
It is possible to write the Latitude and longitude on the fields.
The Show My Location button will try to move the centre of the map to your current location. After centring the map, it will display a grey figure on the map. This location will not be accurate when used on a PC but will be rather accurate when using a tablet with GPS activated.
