CWT-C OS Update for CPU board 0501-E0150

1.Make sure you have the NK.bin and EBOOT.bin files for the correct OS to install in the IMG folder on your SD Boot card

2.Put the SD Boot card into the terminal. See “ Creating a SD Boot card”

3.Power on the terminal

4.Wait for the colour display to say that you may restart the terminal (or wait at least 3 to 4 minutes, if there is no colour display).

5.Turn off the terminal

6.Remove the SC Boot Card

7.Confirm in the OSLOG that the flashing was successful

8.Replace the SC Boot card with the normal SD card

9.Turn on the terminal

If the terminal doesn’t start at all and only shows a blank screen than the bootloader is corrupt and you have to re-install it using JLINK.

If the terminal shows the splash screen on start up but does not continue from there than the OS is corrupt. Verify the SD Boot card and try the installation again.