Barriers allow you to control a separate part of the garage only available for Permit holders and white listed vehicles.
The opening of the barrier can be followed on the Barrier Event Log page.
Zone configuration
To set up a barrier you may want to create a separate zone (child zone) inside an existing zone. In this child zone:
•Set the Parent Zone to the parent garage. this will normally be a garage with standard Flowbird GO - ANPR entry camera control.
•Optionally, enable the "Use Permit Integration" and select a "CWO Parking Zone Key".
As Permit is configured in WebOffice you can find the correct Parking Zone ID there.
•Enable the barrier options listed below.
Lane Configuration for Gate and Relays
Enable any of the following settings in the Barriers tab by toggling the switch:
•Enable Barriers for High Confidence Camera Readings, or
•Enable Barriers for Whitelisted Vehicles, or
•Enable Barriers for Permit
•Continue the lane configuration in
Camera Configuration
Add the communication details for each barrier to the cameras involved.
Normally only the barrier for the incoming lane will be configured. The barrier for the outgoing lane will auto-detect a vehicle and open to let it pass.
See Barrier configuration for this.
After configuring a camera, it will become visible in the Barrier manager.
Here you can open a barrier on request manually.
•When enabling "Open barriers for high confidence Camera readings" only vehicles with a high confidence reading can enter the garage
•When enabled the "Open Barrier for White-listed Vehicles will open the barrier when a white-listed vehicle approaches
•Enabling "Open Barrier for Permit" will open the barrier when a vehicle with an active Permit approaches
•If AntipassBack is ON, there are no changes to the functionality of opening barriers for white-listed vehicles or Permits.
If AntipassBack is OFF, the system permits barriers to open even when no entry session is found for white-listed or Permit vehicles.
This section becomes visible when either "Open Barriers for White-listed Vehicles" or "Open Barriers for Permits" is enabled.
| Note: For Barriers to work in combination with Permit added vehicles, the "Enable permit integration" must be enabled. |
